[mikeyMarine]

i've acquired a 1989 ford f 250 with 85555 original miles on it, it needs a new floor cover, vinyl and pad is worn through on drivers side, I would like to replace the entire thing but cannot find anything on the net but place mats for either side what do I look for and where ?

thanks

 

[Duster]

Check
http://www.JCWhitney.com
check the truck catalog...
look under Carpet & Floor Protection
they list both carpet & rubber
wall to wall molded floor coverings.

 

[NormanB]

In UK ebay loads of suppliers for this sort of stuff maybe try search on US ebay?

 

[Wes_Ingram]

Try here; http://www.lmctruck.com/icatalog/fd/sea ... /fd/t.aspx

I have bought several things from this company, parts always have fit as original. :thumbup:

 

[Dave_J]

Rip it all out, fix any surface rust and then Hurculine it with two coats. http://www.herculiner.com/

 

[mikeyMarine]

they have a 300.00 minimum and I am not sure if they can mask off the inside of the cab , I'm going to get the bed and a foot of the box on each side, and the bumper done , this is getting expensive, my little toy has already cost me $85.00 new ignition switch and new locks for all the boxes, everything was working but the keys were getting worn and I didn't want to get stuck with a good truck and a bad key. saving up for a brake pedal rubber thingy now as the metal is beginning to show through at the bottom , I can haul my burgman around in this thing as the bed is 8 1/2 feet long and 4 feet wide if I ever find a reason to haul it instead of ride it, still have my burgman trust fund ready for the time ,

 

[mike1nw]

Rock Auto.com, I've had good service from them many times.
Or a JY? Decades ago, I replaced the entire floor of my Olds F85 with real carpet for about $25. It was dirty (from the JY) but cleaned up nice.
Pull A Part?

 

[mikeyMarine]

i'll look ayt rock auto , jc whitney sendtd me an outo f sstock, notice and wants me to talk by phone, not happening

 

[mikeyMarine]

sorry about spelling in earlier post

jc whitney? called me at noon today, wanted to re order, cause parts now in stock, :?: needed too much information over the phone to be comfortable with, quoted price of over 300 dollars for 4 screws :shock: :lol: , a couple other mistakes, so I declined to give them my personal info and credit card number over the phone

 

[mikeyMarine]

recieved part from jcwhitney, they subcontracted to lloyds, sent me a floor mat for a tonka vw bug I think, maybe mattel, anyway 22 inches too small in one axis only 1 pre cut hole fit anything