Suzuki Burgman USA Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter · #1 · (Edited)
Broke down and bought the current official Suzuki service manual from Suzuki USA. Now with almost 600 pages, 1-1/4 inches thick. Over $100 with shipping. I'm not sure of the first year for the UH200 sold in the USA, but it appears to be the 2014, and that model is called the UH200AL4. The manual lists additional models and these are AL5, AL6, AL7,AL8,AL9 and ALM0, all corresponding to the years, AL5 being 2015, AL6 the 2016, etc. to the ALM0 the 2020 year.
In looking at the service data information Suzuki repeats each model and they are all the same until the AL7 and then they show one difference in the clutch service data and that is the drive belt width, 22.6 mm (0.89 in) with a service limit 21.6 mm (0.85 in) for the AL4 and AL5, and the clutch shoe thickness 3.0 mm (0.12 in) to limit of 2.0 mm (0.08 in). The AL7 changes are in the drive V-belt with to 21.5 mm (0.84 in) with limit to 20.5 mm and a different clutch shoe thickness of 3.5 mm (0.14 in) to limit of 2.0 mm (0.08 in) the only other difference in years listed is for a wiring diagram in the 2020, ALM0.

As Suzuki does not give much information on the OEM parts one would order, there may be differences in the non OEM parts. When I looked through some discussion threads. The one on the "Malossi belt to wide", for instance there is no mention of which model year the belt was to be used on. Malossi lists this belt as for years 2007 and on, and it's width is 22.2 mm.
 
1 - 1 of 1 Posts
Top