[LeDude]

Completing some of the DIYs that had been on the back burner for a while.

This one is for the: Tupperware - Trunk Box

[youtube:qiv8p61k]3mesN5_yoAE[/youtube:qiv8p61k]

 

[NormanB]

That would have been a good time to fit an accessory socket. :wink:
Thanks for sharing though. :thumbup:

 

[Fatjock]

Thanks for this.

Just wondering if the removal is so simple when the tupperware is still on, or does that have to be removed?

 

[LeDude]

That would have been a good time to fit an accessory socket. :wink: Thanks for sharing though. :thumbup:

have something in the works, will try to finish it and put it together once I get the scoot running.

Thanks for this. Just wondering if the removal is so simple when the tupperware is still on, or does that have to be removed?

The DIY is based on the service manual steps for removing the Trunk Box, step by step.

The DIY has all the specified steps from the service manual, you will have to remove a few pieces of tupperware to get the job done.

 

[Fatjock]

Thanks again.