2006 Burgman 400 has developed a start problem.
Replaced 6-10 amp fuses and 2-15 amp fuses [ouch nothing wrong with them, oh well now I have spares, a tester and a puller], battery fully charged. Kill switch off, kick stand up, key in correct position, lights work, back break lights work too]
Set up, Bike's on center stand: Turned on ignition switch, F1 error [not flashing], kick stand up, lights work, battery fully charged, left rear brake lever engaged--no sound, cranking, or starting.
Same as above but engaged right front brake lever and bike started.
Can hear fuel engaged sound when cranking.
Think solution from somewhere on this forum was left front brake switch? Said parts ran under $200. Need to know so I can order part(s).
Just paid $400+ and change for front bearings, parking cable installation and brake fluid change on both brake lines. Trip down mountain with big jumping and racket when applying front right brake lever. Emergency visit to closest dealer 3 hours out from home location. Trying to keep the new repair down low haven't paid for the last fix yet.
Try removing the relay next to the fuse box on Left side between the headlights and the windshield. Clean the contacts with contact cleaner and re- install. Should fire right up.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
Suzuki Burgman USA Forum
A forum community dedicated to Suzuki Burgman motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more! Open to all 200, 400, and 650 models!