Suzuki Burgman USA Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I just installed a Givi windshield on my 650 because my Clearview XXL broke starting at the top screw holes and then spread to the edge of the windshield. When I took off the Clearview I noticed that the rubber grommets looked to be really worn and paper thin. I did not want to install the new windshield on this as maybe this was the cause of the Clearview breaking. I went to the hardware store and purchased 8 small rubber washers and placed 1 under the windshield at each mounting point and 1 under the screw head thinking this would maybe help to keep the windshield from breaking again.
I then went to install the fascia and the clips are not long enough to clip into the holes. Does anybody think that a very thin washer spaced the windshield out enough that the clips won’t reach? Any suggestions will be appreciated…Tim
 
1 - 1 of 1 Posts
Top