Installing a Clearview vent

1253 Views 12 Replies 5 Participants Last post by thomphoto, Jul 3, 2013

roy_ryall

Discussion Starter · Jul 1, 2013 (Edited)

Has anyone installed or seen a Goldwing WS vent on a Clearview WS? I have a GW1500 vent I was going to install on my GIVI WS, but the curvature is too great on the GIVI WS.

The vents on Clearview WSs look very similar to the vents on GW1800s. I think the curvature on the GW1800 and GW1500 are the same except the hole is smaller on the 1500 and it is all clear plastic instead of the grey plastic pieces on the 1800s.

I like my GIVI's shape, but I would like to have a vent. I discovered on my GW that if you open the vent one notch, it reduced the wing noise and buffeting. I assume the same effect would occur on the Clearview 650 WS?? Comments?

Save

1 - 1 of 13 Posts

DougInKY

· #2 · Jul 1, 2013

Roy, if I was in your situation I would give Clearview a call. I owned one of their windscreens for years on another bike. I always found them easy to talk to on the telephone if I had questions.

Namaste'
Doug in Kentucky

Save

1 - 1 of 13 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month