Suzuki Burgman USA Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Any ideas on what has to be removed to get at the fuse wiring. My hi-beams do not work in any fashion. I find 4-5 volts at the fuse holder and sometimes 12. I put a fuse back in and nothing. the voltage fluctuates when I wiggle the wires, so I need to get where the wire is terminated. Any help will be appreciated.

'06 Burgman 650
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #4 ·
thanks

I tried all the sugestions from previous questions, to no avail. As I have no hi-beams, I cannot flash them on, lites do not go off when starting. When I remove the fuse and turn on the brites, my meter shows about 3-4 volts sitting there. I can wiggle the wiring and raise the vltage to 12 volts, but it will not stay there. Hence, my need to get behind the block. I willl try the new suggestions. I am very concerned my big hands are going to cause additional problems

Thanks again, will let you know. Bill
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top