Suzuki Burgman USA Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter #1
:?: I was looking at taking the plastic off to see where the back rest holes will be drilled. The 2 plastic pins came right out but I wasn't sure of how the bottom of the piece was hooked on. Anyone had this off who could give me a little help?

Thanks in advance!
 

·
Premium Member
Joined
·
3,008 Posts
It slides down about a 1/4 inch to release the hooked tabs on the front part of the tail piece. There is also a rubber gromet you must pull the tail piece out of by putting downward.

You might look at one of the motorcycle shops on-line fiche to see the tabs. MR motorcycles and Ron Ayers has fiche.
 
1 - 3 of 3 Posts
Top