Suzuki Burgman USA Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
466 Posts
Discussion Starter · #1 ·
I installed a Givi V46 silver top box using the SR115 Givi mount. I thought that the large V46 box might be a bit large for the little Burgman but it looks great. The Burgman is wide enough that the box doesn't look out of place. Installation was easy for me but the trimming of the Suzuki plastic pieces may be difficult for some. I used a hole saw and the whole job took less than an hour.
The quality of the Givi pieces is first rate and the silver color was a good match, I'm completely satisfied.

Thanx
Russ
 

·
Registered
Joined
·
466 Posts
Discussion Starter · #3 ·
NormB,

Yeah, you have to take the covers off to cut the holes in them. That's the hardest part of the installation, cutting the holes. I was familiar with how all the pieces come apart but you'll need the service manual to help guide you along. I used a hole saw and cleaned up the edges with a razor blade knife. If you are all thumbs it isn't going to be easy but the box and brackets hide most of the handy work anyway. The covers are molded with lines to help locate where to drill and cut, it took me less than a half hour to cut and trim the two covers. (It took me longer to find my drill motor!)

Thanx
Russ
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top