Suzuki Burgman USA Forum banner

DIY - Oil Level Sensor Repair

2K views 0 replies 1 participant last post by  LeDude 
#1 ·
I never liked the position of the oil level sensor cable, dangling unprotected under the engine.

I knew it was only a matter of time before something happened to it, and as luck would have it, a few weeks before
my CVT went out I noticed a few drops of oil under the engine. After further investigation it was clear that the cable
had taken a hit and was leaking at its base.

Initial quick remedy was to slap on some clear RTV clear silicone which didn't really do a great job of sealing the damaged area.

While I had the scoot apart for my CVT repair, I took the time to remove the sensor and clean it and use JB-Weld to fully encase
the affected damaged area. Hopefully it will hold and won't leak anymore.

Put together a quick DIY for those that may suffer a similar faith. The sensor is rather easy to take out, help in place by two
8 mm bolts.

DIY - Oil Level Sensor Repairs







 
See less See more
7
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top