Suzuki Burgman USA Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi all, I took off the main oil drain plug and the plug next to it. I changed motor oil and filter . I cannot find the fill hole for the main gallery plug. Any help would be appreciated. Thanks
 

·
Registered
Joined
·
1,177 Posts
You dont mess with the gallery plug you drain the oil refill the engine via the
plastic filler plug up to the full line in the oil window with the scooter level
then start the engine the oil pump pumps oil round the engine run it for a few min
stop it let it stand about 3 min and recheck the level.
Never seen a engine were you take the gallery plug out to change the oil,
unless I am misunderstanding your post.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
I made a mistake and I took that plug out first then I knew I screwed it up. Thanks
 

·
Registered
Joined
·
8 Posts
Discussion Starter #4
Gallery plug

You dont mess with the gallery plug you drain the oil refill the engine via the
plastic filler plug up to the full line in the oil window with the scooter level
then start the engine the oil pump pumps oil round the engine run it for a few min
stop it let it stand about 3 min and recheck the level.
Never seen a engine were you take the gallery plug out to change the oil,
unless I am misunderstanding your post.
Are you saying that adding oil in the oil fill will fill the other gallery? 5 ounces came out and it was very clean.
 

·
Registered
Joined
·
1,468 Posts
qman in your profile you don't say what part of Florida you live. If you are anywhere near St. Pete. I would be happy to come take a look at your scooter and help you. There are a lot of Floridians on this forum and if you were a little more specific what part of the state you lived you may find that someone close would offer to help. ;)
 

·
Registered
Joined
·
1,177 Posts
Ok just to put your mind at rest, put all the pugs back in
and the new oil then start the engine for a few secs stop it
and remove the gallery plug you should get a small amount of oil out.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #7
oil gallery

qman in your profile you don't say what part of Florida you live. If you are anywhere near St. Pete. I would be happy to come take a look at your scooter and help you. There are a lot of Floridians on this forum and if you were a little more specific what part of the state you lived you may find that someone close would offer to help. ;)
Hi, model 28 I live in West tampa. Thanks
 

·
Registered
Joined
·
8 Posts
Discussion Starter #8
oil gallery

Ok just to put your mind at rest, put all the pugs back in
and the new oil then start the engine for a few secs stop it
and remove the gallery plug you should get a small amount of oil out.
Thankyou ralph, I really appreciate the information.
 
1 - 8 of 8 Posts
Top