Suzuki Burgman USA Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
227 Posts
Norman, those valve job pics are mine. As you can see, just about everything has to be stripped off the bike to get to the valves. Not difficult, just slow and you have to watch carefully how those flimsy plastic connectors work! I checked mine at 11,000 miles and they were all spot on. I don't think I'll do it again, unless I'm really bored! If you decide to do the job, it's a good idea to take pics along the way and make notes.

Cheers,

Bob
 

· Registered
Joined
·
227 Posts
You've got that right! Just be careful with those plastic tab connectors on some of the body panels - push or pull them the wrong way and they break - don't ask me how I know! If I remember correctly, you need a special torx driver to remove the ignition key assembly, but I managed without removing it. Have fun!

Cheers,

Bob
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top