|
01-risers-manual
The GenMar risers (X102B, black anodized finish) and the "printed" user manual that came with them.
Date: 10/15/07
Views: 232
|
02-stock-clamps
After removal of the plastic cover, here are the stock risers and clamps.
Date: 10/12/07
Views: 206
|
03-releasing-cable-pass
Releasing the front handlebar screws, which also keep the "cable passing" in place. I used a 10mm "L" wrench to do the job.
Date: 10/15/07
Views: 227
|
|
04-T-allen-releasing-clamps
Releasing the stock handlebar clamps. Took an 6mm Allen wrench (mine is a T-shaped Irwin) and a lot of strength, the damn screws were TIGHT indeed.
Date: 10/12/07
Views: 218
|
05-loose-handlebar-risers-in-place
The loose handlebar. The risers are already in place.
Date: 10/15/07
Views: 254
|
06-new-risers-not-handlebar
Just a close shot of the risers in place.
Date: 10/15/07
Views: 239
|
|
07-handlebar-on-risers
Handlebar in position, ready to put the new clamps.
Date: 10/15/07
Views: 224
|
08-riser-final-assembly
Nearly finished. Risers and handlebar in place, just need to tighten the screws.
Date: 10/15/07
Views: 239
|
09-handlebar-cover-still-uncut
After assembly, I reinstalled the handlebar cover, to measure the cutting points. For my surprise, the top piece won't need cutting. Only the lower pieces will require cutting.
Date: 10/15/07
Views: 267
|
